Canon iP3300 Quick Start Guide - Page 15
Loading Paper in the Auto Sheet Feeder, Flatten the four corners of the paper before loading it.
UPC - 013803066265
View all Canon iP3300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
z Loading Paper in the Auto Sheet Feeder 1 Flatten the four corners of the paper before loading it. Note z Align the edges of paper neatly before loading. Loading paper without aligning the edges may cause paper jams. z If paper is curled, hold the opposing curled corners and gently bend them in the opposite direction until the paper becomes completely flat. See "Paper is curled." on page 58. z To avoid curling, handle paper as follows. - Put unused paper back into the package and keep them on a level surface. - Take out only the necessary number of sheets from the package, just before printing. 2 Prepare to load paper. (1) Open the Sheet Feeder Cover and pull out the Paper Support. (2) Open the Front Feeder. (3) Extend the Output Paper Support. (4) Adjust the position of the Paper Thickness Lever. Set it to the right when printing on envelopes or T-shirt transfers, and left when printing on any other type of paper. See "Paper Handling" on page 4. (4) 3 Load the paper. (1) Load the paper in the Auto Sheet Feeder with (A) the print side facing UP. (2) Align the paper stack against the Cover Guide on the right side of the Paper Support. (1) (3) (2) (1) Note Make sure that the Cover Guide is set upright when you load paper in the Auto Sheet Feeder. (3) (3) Pinch the Paper Guide and slide it against the left side of the paper stack. (2) Do not load higher than the Load Limit Mark (A). Before Printing 11