Canon iPF650 iPF650 User Manual - Page 149

Handling rolls Cutting the Leading Edge of Roll Paper Automatically If the leading edge of a roll is crooked or warped, it may cause an error message or printing problems. In this case, set Trim Edge First to Automatic or On in the Paper Menu on the Control Panel to have the printer cut the leading edge to make the edge straight after you load a roll. Trim Edge First offers the following options. • Automatic If the left and right side of the leading edge of the roll ((a) and (b)) are uneven by 3 mm (0.12 in) or more when you load the roll, the edge is cut an amount relative to the slant to ensure a straight edge, and scraps are removed. The edge is not cut if the unevenness is less than 3 mm. However, paper may sometimes be cut, depending on the state of the leading edge. • Off The edge is not cut and scraps are not removed. This setting is Off for most types of paper, by default. For more information, see the Paper Reference Guide. (→P.96) • On The leading edge is cut off when you load a roll, and scraps are removed. The amount of paper cut from the leading edge varies depending on the type of paper. For more information, see the Paper Reference Guide. (→P.96) Follow these steps to change the Trim Edge First setting. 1. On the Tab Selection screen of the Control Panel, press ◄ or ► to select the Paper tab ( ). Note • If the Tab Selection screen is not displayed, press the Menu button. 2. Press the OK button. The Paper Menu is displayed. 3. Press ▲ or ▼ to select Paper Details, and then press the OK button. 4. Press ▲ or ▼ to select the type of paper, and then press the OK button. 5. Press ▲ or ▼ to select Trim Edge First, and then press the OK button. 6. Press ▲ or ▼ to select the desired setting option, and then press the OK button. This setting takes effect the next time you load a roll. Handling Paper 133