Canon imagePROGRAF TX-3000 MFP T36 series User Manual - Page 240

Cut to standard size Specifies standard size as the output page size when printing on roll paper. Select this setting item from Device settings > Print settings > HP-GL/2 print settings > Paper settings. • If OFF (Initial setting) is selected: Cutting according to standard size is not performed. • If ON is selected: Cuts to standard size in accordance with the roll paper width. When there are two lengths/widths applicable for a given roll paper width, the optimum size is selected automatically. Note • Nesting cannot be performed while ON is selected. • If ON is selected for Conserve paper and there is blank space above/below the image, the size will not be standard size. • When ON is selected for Print centered, printing will be in the center of the standard size. • If there is no standard size corresponding to the roll paper width, operation is the same as if OFF is selected. No message is displayed. • When there are multiple width/length candidates in the roll 1 (upper) and roll 2 (lower) in a double- roll printer model, the optimum standard size is selected automatically under the following conditions. • When any of the candidates accommodates the output page size, the standard size closest to the minimum image range is selected for efficient printing. • When none of the candidates accommodates the output page size, the largest standard size is selected to expand the print range. • For information about supported standard sizes, see the appendix at the back of this manual. STANDARD CUT EXAMPLES • A3-size width roll paper A. Position of cut when OFF B. Position of cut when ON • A3-size width roll paper 240