Canon imagePROGRAF TX-3000 MFP T36 series User Manual - Page 68

• Be careful not to soil the printing surface of roll paper as you insert it in the slot. This may affect the printing quality. We recommend wearing clean cloth gloves when handling rolls to protect the printing surface. • If the paper is wrinkled or warped, straighten it out before loading it. • Load the roll so that there is no gap between the right edge of the paper and the Roll Holder. • Depending on the paper, the roll paper may be scratched when being fed and not feed well. In this case, you must feed the paper manually after setting Paper retention setting to Release on the touch screen. Lift the release lever, advance the roll paper until its leading edge appears on platen, lower the release lever, and then proceed to the next step. However, if Paper retention setting is set to Release, automatic switching of the upper and lower rolls is not possible. Once paper feeding starts, you will need to do the following, based on the Manage remaining roll amount setting and the barcode printed on rolls. (See "Keeping Track of the Amount of Roll Paper Left.") • When selecting Disable or Warning message in Manage remaining roll amount. A menu for selecting the media type appears on the touch screen. Operate the touch screen and select the media type to be used. • When selecting Barcodes in Manage remaining roll amount and if the barcode is printed. The type and amount of paper left is automatically detected based on the barcode printed on the roll. There is no need to specify the type and length of the paper. • When selecting Barcodes in Manage remaining roll amount and if the barcode is not printed. A menu for selection of the media type and length is shown on the touch screen. Operate the touch screen, select the media type to be used, and enter its length. Important • When selecting Enable in Keep media type, there is no need to specify the type of the paper. • Cut the edge of the roll using the Cut paper function if the edge is creased or soiled. (See "Specifying the Cutting Method for Rolls.") • When selecting the media type on the touch screen, make sure the media type set in the printer driver and the media type loaded on the printer match. 68