Canon imagePROGRAF iPF825 MFP M40 iPF815/iPF825 Basic Guide No.1 - Page 12

Attaching the Roll Holder to Rolls Attach the roll holder to rolls as follows. When printing on rolls, attach the Roll Holder to the roll. Rolls have a two- or three-inch paper core. Use the correct attachment for the paper core. The printer comes equipped with the 2-Inch Paper Core Attachment installed. Paper to • Using the 2-Inch Paper Core Attachment Prepare 2-Inch Paper Core Attachment (a) • Using the 3-Inch Paper Core Attachment 3-Inch Paper Core Attachment #1 (b) 3-Inch Paper Core Attachment #2 (c) (a) (b) (c) • Set the roll on a table or other flat surface so that it does not roll or fall. Rolls are heavy, and dropping a roll may cause injury. • Cut the edge of the roll paper if it is uneven, dirty, or has tape residue. Otherwise, it may cause feeding problems and affect the printing quality. Be careful not to cut through any barcodes printed on the roll. • Align the edges of the paper on both ends of the roll. • For details on supported sizes and types of rolls, see "Paper Sizes" or the Paper Reference Guide. (→"Paper Sizes," User Manual) (→"Types of Paper," User Manual) • After pressing the Load/Eject button, you can refer to instructions on the Display Screen as you load the paper. 1 Lift the Holder Stopper lever (a) from the shaft side to unlock it. Holding the Holder Stopper at the position indicated (b), remove it from the Roll Holder. a b 2 When using a 3-inch paper core, align the tips (a) of 3-Inch Paper Core Attachment #1 with the holes (b) of b the Roll Holder and insert it firmly. a 12