Canon imagePROGRAF iPF825 MFP M40 iPF815/iPF825 Basic Guide No.1 - Page 14
Loading Rolls in the Printer
View all Canon imagePROGRAF iPF825 MFP M40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Loading Rolls in the Printer Load rolls in the printer as follows. You can load rolls in two positions, in the Roll 1 (Upper) and Roll 2 (Lower) holders. (iPF825 only) • Remove any loaded paper that will not be used. • Rolls: (→ , Removing the Roll from the Printer) • Sheets: (→ , Removing Sheets) • If the Wheeled Output Stacker is installed, remove it in advance. (→"Using the Wheeled Output Stacker," User Manual) • If the Platen is dirty, clean inside the Top Cover. (→ , If Paper is Soiled) • After pressing the Load/Eject button, you can refer to instructions on the Display Screen as you load the paper. (→"Checking Instructions During Printer Operations," User Manual) Load a roll in the printer (iPF825: in the Roll 1 (Upper) position) 1 Confirm that a roll is selected as the paper source. (→"Selecting the Paper Source," User Manual) OK 2 Open the Top Cover and lift the Ejection Guide. 3 Holding the Roll Holder so that the side with the white gear faces the side of the Roll Holder Slot with a white gear, load the Roll Holder shaft (a) into the grooves (b) on both ends of the Roll Holder Slot. ba ab • Be careful not to pinch your fingers between the Roll Holder shaft (a) and the guide grooves (b) when loading rolls. • See the following procedure for instructions on attaching the Roll Holder to the roll. (→ , Attaching the Roll Holder to Rolls) 14