Canon imagePROGRAF iPF8300 iPF8300 User Manual ver.1.20 - Page 1103

Error Message > Messages regarding paper > Cause Because the Platen is soiled with ink or other substances, the size of the clear film cannot be detected. Corrective Action (See "Loading Rolls in the Printer.") →P.777 If this error recurs after you reload the roll, remove the Roll Holder from the printer, push the roll firmly in until it touches the Roll Holder flange, and reload the Roll Holder in the printer. (See "Attaching the Roll Holder to Rolls.") →P.774 Follow these steps to reload the sheet. 1. Lift the Release Lever. 2. Adjust the right edge of the sheet to make it parallel to the right Paper Alignment Line and the trailing edge of the sheet to make it parallel to the paper alignment line under the Paper Retainer. 3. If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press the OK button. Printing will resume, starting from the page on which the error occurred. (See "Loading Sheets in the Printer.") →P.802 Open the Top Cover and clean the entire Platen. (See "Cleaning Inside the Top Cover.") →P.1026 Insufficient paper for job Cause The printer has received a print job longer than the amount of roll paper left when ManageRemainRoll in the Control Panel menu is On. Corrective Action Press ▲ or ▼ to select Print, and then press the OK button to resume printing. When using the Media Takeup Unit, press ▲ or ▼ to select Print, and then press the OK button to resume printing. However, the roll paper may run out during the print job and you may not be able to print all of the document. 13 1085 iPF8300 Insufficient paper for job