Canon imagePROGRAF iPF840 MFP M40 User Guide - Page 612

Roll paper cannot be inserted into the Paper Feed Slot 8 Lower the Release Lever and close the Top Cover. iPF840 9 In a crouching position, push the Roll Unit in. Troubleshooting Problems Regarding Paper 10 Position the Wheeled Output Stacker by the printer. (See "Using the Wheeled Output Stacker.") ➔P.375 11 Turn the printer on. (See "Turning the Printer On and Off.") ➔P.17 Roll paper cannot be inserted into the Paper Feed Slot Cause The roll paper is warped. Paper is jammed by the paper feed slot. The paper source selection is incorrect. If paper cannot be advanced from Roll 2 (Lower), the Roll Unit Cable is disconnected. Corrective Action Straighten out curls and reload the roll. Remove the jammed paper. (See "Clearing Jammed Roll Paper.") ➔P.605 (See "Clearing a Jammed Sheet.") ➔P.608 Press the Load button and select the paper source. Connect the Roll Unit Cable firmly to the Roll Unit Power Supply Inlet and the inlet on the roll unit. Cannot load sheets Cause Corrective Action The paper source selection is incorrect. Press the Load button and select the paper source. Paper is not cut neatly 612 Cause The paper is bent or curled at the cut position. Corrective Action Straighten out any curling by the edges of the paper. Paper rises by the ends of the cut position before it is cut. Reload the paper correctly. You are using paper that cannot be cut with the Cutter Unit. Specify Manual in Cutting Mode in the Control Panel menu and use scissors or a cutting tool to cut the roll after printing. (See "Specifying the Cutting Method for Rolls.") ➔P.360 User's Guide