Cisco ASR1002 Installation Guide - Page 7

Chapter 8 Cisco ASR 1002 Router Overview and Installation Cisco ASR 1002 Router Description The power supplies are installed into the rear of the chassis and are hot pluggable. The Cisco ASR 1002 Router supports up to 588 W input power from an infrastructure standpoint (cooling capacity, midplane and power distribution) but initial power supply development limit is up to 470 W output (AC and DC Input). AC Power Supply for Cisco ASR 1002 Router The AC power supply input inlet is an IEC connector with AC switch and the current rating on the connector and switch is 10 Amps. The AC power supply is secured into the chassis with two captive screws mounted on the faceplate. Table 8-2 describes the AC power supply LEDs on the Cisco ASR 1002 Router. Table 8-2 Cisco ASR 1002 Router AC Power Supply LEDs LED Label INPUT OK LED Power supply activity Color Green None FAN OK OUTPUT FAIL Power supply fan activity Green A bi-color LED indicates fan status. Red Power supply activity Red Description LED is green and signals that the AC power supply input voltage is greater than 85 V. If LED is not lighted, the AC input voltage is less than 70 V or the power supply is turned off. For an AC input voltage between 70 V and 85 V the INPUT OK LED can be either on, off, or flashing The LED is illuminated green when all fans are operational. The LED is illuminated red when a fan failure is detected. LED is red. It is off to signal that the DC output voltages are within the normal operating range. Output voltage between the minimum and maximum limits will not create an output fail alarm and output voltages below the minimum or above the maximum will create an output fail alarm. Figure 8-6 shows the AC Power Supply for the Cisco ASR 1002 Router. Figure 8-6 AC Power Supply for the Cisco ASR 1002 Router 12 34 5 6 0 OUTPUT INPUT FAN FAIL OK OK This unit might have more than one power supply connection. All connections must be removed to de-energize the unit. OUTPUT INPUT FAN FAIL OK OK This unit might have more than one power supply connection. All connections must be removed to de-energize the unit. 280288 1 8 7 OL-13208-09 Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide 8-7