Cisco SR224T-NA Administration Guide - Page 131

Smartports Configuring Smartport Using The Web-based Interface 10 Workflow4: To rerun a Smartport macro after it has failed, perform the following steps: STEP 1 In the Interface Settings page, select an interface with Smartport type Unknown. STEP 2 Click Show Diagnostics to see the problem. STEP 3 Troubleshoot, then correct the problem. See the troubleshooting tip below. STEP 4 Click Edit. A new window opens in which you can click Reset to reset the interface. STEP 5 Return to the main page and reapply the macro using either Reapply (for devices that are not switches, routers or APs) or Reapply Smartport Macro (for switches, routers or APs) to run the Smartport Macro on the interface. A second method of resetting single or multiple unknown interfaces is: STEP 1 In the Interface Settings page, select the Port Type equals to checkbox. STEP 2 Select Unknown and click Go. STEP 3 Click Reset All Unknown Smartports. Then reapply the macro as described above. TIP The reason that the macro failed might be a conflict with a configuration on the interface made prior to applying the macro (most often encountered with security and storm-control settings), a wrong port type, a typo or an incorrect command within the user-defined macro, or an invalid parameter setting. Parameters are checked for neither type nor boundary prior to the attempt to apply the macro, therefore, an incorrect or invalid input to a parameter value will almost assuredly cause failure when applying the macro. Configuring Smartport Using The Web-based Interface The Smartport feature is configured in the Smartport > Properties, Smartport Type Settings and Interface Settings pages. For Voice VLAN configuration, see Voice VLAN. For LLDP/CDP configuration, see the Configuring LLDP and Configuring CDP sections, respectively. Cisco Small Business 200 Series Smart Switch Administration Guide 132