Compaq Elite 8300 Maintenance & Service Guide Elite 8300 Touch All-in-One - Page 128
Hood sensor
View all Compaq Elite 8300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
Hood sensor The hood sensor is located on the bottom left of the computer (when viewed from behind). Figure 7-85 Hood sensor location To remove the hood sensor: 1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 40). 2. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 40). 3. Remove the access panel (see Access panel on page 45). 4. Remove the stand (see Stand on page 48). 5. Remove the lower panel (see Lower panel on page 50). 6. Remove the side panels (see Side panels on page 88). 7. Remove the metal plate (see Metal plate on page 51). 8. Remove the power supply (see Power supply on page 90). 9. Remove the system board (see System board on page 93). 10. Remove the front bezel (see Front bezel on page 105). 11. Remove the display panel (see Display panel on page 111). 12. Disconnect the hood sensor cable from the system board connector labeled HSENSE. 118 Chapter 7 Removal and Replacement Procedures All-in One (AIO) Chassis