Compaq Elite 8300 Maintenance & Service Guide Elite 8300 Touch All-in-One - Page 80
Converter board
View all Compaq Elite 8300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
Converter board The converter board is located on the left side of the computer (viewed from behind) under the main rear cover. It is secured with two Torx screws and has two connectors. Use the same converter spare part for all display panels; however, you must change jumper settings on the board based on the display panel. Figure 7-40 Converter board location To remove the converter board: 1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 40). 2. Remove the access panel (see Access panel on page 45). 3. Disconnect the two cables from the board (1). NOTE: Be careful not to damage the cables when disconnecting them from the board. Do not pull on the wires. 70 Chapter 7 Removal and Replacement Procedures All-in One (AIO) Chassis