Compaq Elite 8300 Maintenance & Service Guide Elite 8300 Touch All-in-One - Page 130
Hard drive and optical drive cables and connectors
View all Compaq Elite 8300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 130 highlights
Hard drive and optical drive cables and connectors The hard drive and optical drive connectors are located near the middle of the computer, partially under the main display bracket. Each connector is secured with two Torx screws and has two cables that connect to the system board. The optical drive connector cables are longer than the hard drive connector cables. Figure 7-88 Hard drive cable and optical drive cable location To remove the hard drive or optical drive connector: 1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 40). 2. Remove the access panel (see Access panel on page 45). 3. Remove the stand (see Stand on page 48). 4. Remove the lower panel (see Lower panel on page 50). 5. Remove the side panels (see Side panels on page 88). 6. Remove the metal plate (see Metal plate on page 51). 7. Remove the power supply (see Power supply on page 90). 8. Remove the system board (see System board on page 93). 9. Remove the front bezel (see Front bezel on page 105). 10. Remove the display panel (see Display panel on page 111). 11. Remove two Torx screws that secure the hard drive connector or the optical drive connector to the computer. 120 Chapter 7 Removal and Replacement Procedures All-in One (AIO) Chassis