Compaq ProLiant 8500 Compaq ProLiant 8500 Setup and Installation Guide - Page 79
Installing the Cache Accelerator
View all Compaq ProLiant 8500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
Installing Hardware Options 4-11 Installing the Cache Accelerator The cache accelerator is an option is required for five or more processors. The cache accelerator option should not be used for less than five processors. The following paragraphs provide guidelines on determining which configuration is best for your system. ProLiant 8500 servers have two processor buses. In the following figure, processor sockets 1 through 4 are on processor bus 1. Socket ; is for Cache Accelerator 1. Processor sockets 5 through 8 are on processor bus 2 with socket < for Cache Accelerator 2. 1 2 3 4 11 12 5 6 7 8 13 14 9 10 Figure 4-11. Processor board layout Processors should be added to fill bus 1 before adding processors to bus 2. If processors occupy slots of both processor buses, then the Cache Accelerators for both buses must be installed for proper operation. To install the cache accelerator in the Processor and Memory module, refer to one of the following installation sources: s For a text and illustrated procedure, refer to the documentation provided with the option kit. s For an overview of the installation, see the procedure below. 1. If the server is on, place it in Standby and disconnect the power cord(s). See Chapter 2, "Server Installation." 2. Remove the Processor and Memory module. See Chapter 3, "Server Operation."