Compaq ProLiant 8500 Compaq ProLiant 8500 Setup and Installation Guide - Page 88
Installing a Hot Plug SCSI Hard Disk Drive
View all Compaq ProLiant 8500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
4-20 Compaq ProLiant 8500 Servers Setup and Installation Guide Installing a Hot Plug SCSI Hard Disk Drive CAUTION: Before adding or removing any hot-plug SCSI drives, consult your operating system instructions. Failure to do so could result in loss of data or damage to equipment. To install a hot-plug SCSI hard drive: 1. Remove the blanking panel in an unused drive bay by pushing the side of the retaining clip inward , then pulling the blanking panel outward . 1 2 Figure 4-18. Removing a hard-drive blanking panel 2. Push the release button on the left of the new drive and rotate the hot- plug drive ejector lever outward to unlock.
4-20
Compaq ProLiant 8500 Servers Setup and Installation Guide
Installing a Hot Plug SCSI Hard Disk Drive
CAUTION:
Before adding or removing any hot-plug SCSI drives, consult your
operating system instructions. Failure to do so could result in loss of data or
damage to equipment.
To install a hot-plug SCSI hard drive:
1.
Remove the blanking panel in an unused drive bay by pushing the side
of the retaining clip inward
±
, then pulling the blanking panel
outward
²
.
2
1
Figure 4-18.
Removing a hard-drive blanking panel
2.
Push the release button on the left of the new drive and rotate the hot-
plug drive ejector lever outward to unlock.