D-Link DCH-M225 User Manual - Page 15

Connect Your DCH-M225 to Your Router Using WPS

Get D-Link DCH-M225 PDF manuals and user guides View all D-Link DCH-M225 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

Section 2 - Product Setup Connect Your DCH-M225 to Your Router Using WPS The easiest and most secure way to connect your DCH-M225 to your the router or access point is with WPS (Wi-Fi Protected Setup). Refer to your user manual for your router or access point to make sure you understand how to enable WPS. Once you know, follow the steps below: Step 1 - Find an available outlet near your wireless router. Plug in the DCH-M225, and wait until the LED starts blinking amber. Step 2 - Press the WPS button on your wireless router. Note: Usually the WPS LED will blink once it is pressed. Check your router's user manual for more information. Step 3 - Within one minute, press and hold the WPS button on the DCH-M225 until the LED starts blinking green and then release. Allow up to two minutes for the WPS process to complete. WPS Button WPS Button D-Link DCH-M225 User Manual 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
11
D-Link DCH-M225 User Manual
Section 2 - Product Setup
Connect Your DCH-M225 to Your Router Using WPS
Step 2
- Press the
WPS
button on your wireless router.
The easiest and most secure way to connect your DCH-M225 to your the router or access point is with WPS (Wi-Fi Protected
Setup). Refer to your user manual for your router or access point to make sure you understand how to enable WPS. Once you
know, follow the steps below:
Step 1
- Find an available outlet near your wireless router. Plug in the DCH-M225,
and wait until the LED starts blinking amber.
Step 3
- Within one minute, press and hold the
WPS
button on the DCH-M225
until the LED starts blinking green and then release. Allow up to two
minutes for the WPS process to complete.
WPS Button
Note:
Usually the WPS LED will blink once it is pressed. Check your router’s
user manual for more information.
WPS Button