D-Link DCH-M225 User Manual - Page 24

WPS Button, Select this, option if you want to set up your network manually, Wi-Fi Network, Select

Get D-Link DCH-M225 PDF manuals and user guides View all D-Link DCH-M225 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

Section 2 - Product Setup 3. The DCH-M225 uses the push-button method for WPS. Press and hold the WPS button on your wireless router or access point until the light starts blinking green. Allow up to two minutes for the WPS process to finish. When a connection is successfully established, the LED on the device should turn solid green. Note: Refer to your router or access point's user manual instructions for more information about the WPS process. 4. If your wireless device does not support WPS, click Select this option if you want to set up your network manually. Click Next to continue. WPS Button 5. Wait while your DCH-M225 scans for available Wi-Fi networks. You will see a list of networks found. Select the Wi-Fi Network you wish to use, click Select. Note: If the network you would like to connect to isn't listed, click Back and select the manual option again to perform another scan. Make sure you are in range of your wireless router. D-Link DCH-M225 User Manual 20

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
20
D-Link DCH-M225 User Manual
Section 2 - Product Setup
WPS Button
3. The DCH-M225 uses the push-button method for WPS. Press and
hold the
WPS
button on your wireless router or access point
until the light starts blinking green. Allow up to two minutes
for the WPS process to finish. When a connection is successfully
established, the LED on the device should turn solid green.
Note:
Refer to your router or access point’s user manual instructions
for more information about the WPS process.
4. If your wireless device does not support WPS, click
Select this
option if you want to set up your network manually
.
Click
Next
to continue.
5. Wait while your DCH-M225 scans for available Wi-Fi networks. You
will see a list of networks found. Select the
Wi-Fi Network
you
wish to use, click
Select
.
Note:
If the network you would like to connect to isn’t listed, click
Back
and select the manual option again to perform another scan.
Make sure you are in range of your wireless router.