D-Link DES-3852 Product Manual - Page 199
Auto Config Commands V3, Purpose, Syntax, enable autoconfig, Description, Parameters, Restrictions
UPC - 790069289460
View all D-Link DES-3852 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 199 highlights
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual 28 AUTO CONFIG COMMANDS V3 The auto config function enables the Switch to obtain its configuration from a TFTP server upon booting up. Command enable autoconfig disable autoconfig show autoconfig Parameters Each command is listed, in detail, in the following sections. enable autoconfig Purpose Syntax Description Parameters Restrictions Enables the auto-config function and after rebooting, the system will adopt the configuration file from the tftp server. enable autoconfig When this function is enabled, the system ip interface will be changed to DHCP mode immediately. After rebooting the system it will try to get the configuration file from the TFTP server, whose information is configured in the DHCP server. When the system gets the configuration file from the TFTP server, it will apply the configuration to the system. If the system fails to get a configuration file, the Switch will use the local configuration file for booting. None. Only Administrator or Operator-level users can issue this command. Example usage: To enable autoconfig. DES-3800:admin#enable autoconfig Command: enable autoconfig Success DES-3800:admin# 195