D-Link DES-3852 Product Manual - Page 50
config poe system, power_disconnect_method [deny_next_port
UPC - 790069289460
View all D-Link DES-3852 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual config poe system Purpose Used to configure the parameters for the whole PoE system. Syntax Description Parameters Restrictions config poe system {power_limit | power_disconnect_method [deny_next_port | deny_low_priority_port} Allows the user to configure the parameters for the whole PoE system. power_limit - The power limit parameter allows the user to configure the power budget of whole PoE system. The minimum setting is 37 W and the maximum is 370W (depending on the power supplier's capability). Default setting is 370 W. power_disconnect_method -This parameter is used to configure the power management disconnection method. When the total consumed power exceeds the power budget, the PoE controller initiates a port disconnection to prevent overloading the power supply. The controller uses one of the following two ways to implement the disconnection: deny_next_port - After the power budget has been exceeded, the next port attempting to power up is denied, regardless of its priority. deny_low_priority_port - After the power budget has been exceeded, the next port attempting to power up, causes the port with the lowest priority to shut down (to allow high-priority ports to power up). The default setting is deny_next_port. Only Administrator or Operator-level users can issue this command. Example usage: To config the PoE System on the Switch: DES-3800:admin#config poe system power_limit 300 power_disconnect_method deny_next_port Command: config poe system power_limit 300 power_disconnect_method deny_next_port Success. DES-3800:admin# config poe ports Purpose Syntax Description Parameters Used to configure the PoE port settings. config poe ports [all | ] {state [enable | disable] | priority [critical | high | low] | power_limit [class_0 | class_1 | class_2 | class_3 | user_define ]} The config poe ports command is used to configure the PoE port settings. -Specifies a range of ports to be configured or all the ports. all - Specifies that all ports (port 1-24) on the Switch will be configured for PoE. state - Enables or disables the PoE function on the Switch. 46