D-Link DGS-1510 Quick Install Guide - Page 51
Consignes de sécurité, Précautions de sécurité
View all D-Link DGS-1510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
DGS-1510 Series Gigabit Ethernet SmartPro Switch Hardware Installation Guide voltage and current marked on the product's electrical ratings label. The voltage and current rating of the cable should be greater than the ratings marked on the product. • To help prevent electric shock, plug the system and peripheral power cables into properly grounded electrical outlets. These cables are equipped with three-prong plugs to help ensure proper grounding. Do not use adapter plugs or remove the grounding prong from a cable. If using an extension cable is necessary, use a 3-wire cable with properly grounded plugs. • Observe the extension cable and power strip ratings. Make sure that the total ampere rating of all products plugged into the extension cable or power strip does not exceed 80 percent of the ampere ratings limit for the extension cable or power strip. • To help protect the system from sudden, transient increases and decreases in electrical power, use a surge suppressor, line conditioner, or uninterruptible power supply (UPS). • Position system cables and power cables carefully. Route cables so that they cannot be stepped on or tripped over. Be sure that nothing rests on any cables. • Do not modify power cables or plugs. Consult a licensed electrician or your power company for site modifications. Always follow your local or national wiring rules. When connecting or disconnecting power to and from hot-pluggable power supplies, observe the following guidelines: • Install the power supply before connecting the power cable to the power supply. • Unplug the power cable before removing the power supply. • If the system has multiple sources of power, disconnect power from the system by unplugging all power cables from the power supplies. • Move products with care and ensure that all casters and stabilizers are firmly connected to the system. Avoid sudden stops and uneven surfaces. To help avoid damage to the system, be sure that the voltage selection switch, on the power supply, is set to match the power available at the Switch's location: • 115V/60Hz is used mostly in North and South America as well as Far Eastern countries like as South Korea and Taiwan • 100V/50Hz is used mostly in Eastern Japan and 100V/60Hz in Western Japan • 230V/50Hz is used mostly in Europe, the Middle East, Africa and the Far East Consignes de sécurité Veuillez prêter une attention particulière aux consignes de sécurité suivantes pour assurer votre sécurité personnelle et protéger votre système des dommages potentiels. Précautions de sécurité Pour réduire considérablement les risques de blessure physique, de choc électrique, d'incendie et de détérioration du matériel, observez les précautions suivantes. Observez et respectez les marquages relatifs à l'entretien et/ou aux réparations. • N'essayez pas de réparer un produit, sauf si cela est expliqué dans la documentation du système. • L'ouverture ou le retrait des capots, signalés par un symbole de haute tension, peut exposer l'utilisateur à un choc électrique. • Seul un technicien de maintenance qualifié est habilité à réparer les composants à l'intérieur de ces compartiments. 51