D-Link DGS-1520 Emulator - Page 838

DGS-1520 Series Gigabit Ethernet Smart Managed Switch CLI Reference Guide Example This example shows how to display the PoE power inline status on ports 1 to 8. Switch#show poe power-inline eth1/0/1-8 status Interface State Class Max(W) Used(W) Description eth1/0/1 delivering class-1 4 3.4 IP-camera-1 eth1/0/2 delivering class-2 10 6.3 1234567890 eth1/0/3 delivering class-3 15.4 13.0 eth1/0/4 delivering class-3 15.4 1.4 access123 eth1/0/5 searching n/a 0.0 0.0 eth1/0/6 searching n/a 0.0 0.0 eth1/0/7 searching n/a 0.0 0.0 eth1/0/8 searching n/a 0.0 0.0 Faulty code [1] MPS (Maintain Power Signature) Absent [2] PD short [3] Overload [4] Power Denied [5] Thermal Shutdown [6] Startup Failure [7] Classification Failure Switch# Display Parameters Interface State Class Max(W) Used(W) Description The PoE interface ID. The port status can be of the following: Disabled: The PSE function is disabled. Searching: The remote PD is not connected. Requesting: The remote PD is inserted, but the PSE does not provide power yet. Delivering: The remote PD is now powering by PoE system. Faulty[X]: The device detection or a powered device is in a faulty state. X is the error code number. • [1] - MPS (Maintain Power Signature) Absent. • [2] - PD Short. • [3] - Overload. • [4] - Power Denied. • [5] - Thermal Shutdown. • [6] - Startup Failure. • [7] - Classification Failure(IEEE 802.3at). The IEEE classification: N/A or a value from IEEE class 0 to 4. The maximum amount of power could be allocated to the powered device in watts. The amount of power is currently allocated to PoE ports in watts. The configured description of the connected PD. 834