D-Link DGS-1520 Emulator - Page 9

DGS-1520 Series Gigabit Ethernet Smart Managed Switch CLI Reference Guide Observe the following example. Switch#enable Switch#configure terminal Switch(config)#username user1 password 1234 Switch(config)#username user1 privilege 15 Switch(config)#line console Switch(config-line)#login local Switch(config-line)# In the above example, we had to navigate and access the username command. • Starting in the User EXEC Mode, we enter the enable command to access the Privileged EXEC Mode. • After accessing the Privileged EXEC Mode, we entered the configure terminal command to access the Global Configuration Mode. The username command can be used in the Global Configuration Mode. • The username user1 password 1234 command creates a user account with the username of user1 and a password of 1234. • The username user1 privilege 15 command assigns a privilege level value of 15 to the user account admin. • The line console command allows us to access the console interface's Line Configuration Mode. • The login local command tells the Switch that users need to enter locally configured login credentials to access the console interface. Save the running configuration to the start-up configuration. This means to save the changes made so that when the Switch is rebooted, the configuration will not be lost. The following example shows how to save the running configuration to the start-up configuration. Switch#copy running-config startup-config Destination filename startup-config? [y/n]: y Saving all configurations to NV-RAM.......... Done. Switch# After the Switch has rebooted, or after the users log out and back in, the newly created username and password must be entered to access the CLI interface again, as seen below. DGS-1520-28MP Gigabit Ethernet Smart Managed Switch Command Line Interface Firmware: Build 1.00.022 Copyright(C) 2020 D-Link Corporation. All rights reserved. User Access Verification Username:user1 Password:**** Switch# Interface Notation When configuring the physical ports available on this switch, a specific interface notation is used. The following will explain the layout, terminology and use of this notation. 5