D-Link DGS-1520 Emulator - Page 946

DGS-1520 Series Gigabit Ethernet Smart Managed Switch CLI Reference Guide 2000Kbps, and bronze is configured to match CoS 0 and be policed by a single rate policer with a committed rate of 8000Kbps. For cust2-classes, gold is configured to use Cos Queue 6 and be policed by a single rate policer with a committed rate of 1600 Kbps. Silver is policed by a single rate policer with a committed rate of 4000 Kbps, and bronze is policed by a single rate policer with a committed rate of 16000 Kbps. The cust1-classes policy map is configured and then attached to ports 1 and 2 for ingress traffic. Switch#configure terminal Switch(config)#class-map match-all gold Switch(config-cmap)#match cos 6 Switch(config-cmap)#exit Switch(config)#class-map match-all silver Switch(config-cmap)#match cos 5 Switch(config-cmap)#exit Switch(config)#class-map match-all bronze Switch(config-cmap)#match cos 0 Switch(config-cmap)#exit Switch(config)#policy-map cust1-classes Switch(config-pmap)#class gold Switch(config-pmap-c)#police 800 2000 exceed-action set-dscp-transmit 0 Switch(config-pmap-c)#exit Switch(config-pmap)#class silver Switch(config-pmap-c)#police 2000 2000 exceed-action set-dscp-transmit 0 Switch(config-pmap-c)#exit Switch(config-pmap)#class bronze Switch(config-pmap-c)#police 8000 2000 exceed-action set-dscp-transmit 0 Switch(config-pmap-c)#exit Switch(config-pmap)#exit Switch(config)#interface eth1/0/1 Switch(config-if)#service-policy input cust1-classes Switch(config-if)#exit Switch(config)#interface eth1/0/2 Switch(config-if)#service-policy input cust1-classes Switch(config-if)# 83-21 set This command is used to configure the new precedence field, DSCP field, and CoS field of the outgoing packet. The user can also specify the CoS queue for the packet. Use the no form of this command to remove the set. set {[ip] precedence PRECEDENCE | [ip] dscp DSCP | cos COS | cos-queue COS-QUEUE} no set {[ip] precedence PRECEDENCE | [ip] dscp DSCP | cos COS | cos-queue COS-QUEUE} Parameters [ip] precedence PRECEDENCE [ip] dscp DSCP Specifies a new precedence for the packet. The valid range is from 0 to 7. ip - (Optional) Specifies to mark that IPv4 precedence. If this parameter is not specified, both IPv4 and IPv6 precedence will be marked. For IPv6 packets, the precedence is the most three significant bits of traffic class of IPv6 header. Setting the precedence will not affect the CoS queue selection. Specifies a new DSCP for the packet. The valid range is from 0 to 63. ip - (Optional) Specifies to mark that IPv4 DSCP. If this parameter is not specified, both IPv4 and IPv6 DSCP will be marked. Setting DSCP will not affect the CoS queue selection. 942