D-Link DGS-1520 Emulator - Page 898

DGS-1520 Series Gigabit Ethernet Smart Managed Switch CLI Reference Guide Usage Guideline This command only affects PIM-SM operation. Only one group access list can be specified for each interface. The latest configuration overrides the previous one. This command can be issued multiple times for different interfaces. This command causes the router to send a PIMv2 message advertising itself as a candidate RP to the BSR. Example This example shows how to configure the router with the interface VLAN 1 to be advertised as the candidate RP with a priority of 10. Switch#configure terminal Switch(config)#ipv6 pim bsr candidate rp vlan1 priority 10 Switch(config)# 81-5 ipv6 pim dr-priority This command is used to change the Designated Router (DR) priority value inserted into the DR priority option of the PIM Hello messages. Use the no form of this command to revert to the default setting. ipv6 pim dr-priority PRIORITY no ipv6 pim dr-priority Parameters PRIORITY Specifies the value of the DR priority in the range of 0 to 4294967295. A larger value means a higher priority. Default By default, this value is 1. Command Mode Interface Configuration Mode. Command Default Level Level: 12. Usage Guideline This command only takes effective when the interface is PIM-SM mode enabled. When a DR is a candidate for election, the following conditions apply: • The router with the highest priority value configured on an interface will be elected as the DR. If multiple routers have the same highest priority, the router with the highest IPv6 address configured on the interface will be elected as the DR. • If a router does not advertise a priority value in its hello messages, the router is regarded as having the highest priority and will be elected as the DR. If there are multiple routers do not include the DR priority option in their hello messages, the router with the highest IPv6 address will be elected as the DR. 894