D-Link DGS-3630-28SC Web UI Reference Guide 2 - Page 244

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide Figure 6-26 IPv6 Route Table Window The fields that can be configured are described below: Parameter IPv6 Address IPv6 Address/Prefix Length Interface Name Connected RIPng OSPFv3 ISIS BGP Database Hardware Summary Description Select and enter the IPv6 address to display here. Select and enter the IPv6 address and prefix length to display here. Select the Longer Prefixes option to display the route and all of the more specific routes. Select and enter the name of the interface to display here. Select this option to display only connected routes. Select this option to display only RIPng routes. Select this option to display only OSPFv3 routes. Select this option to display only ISIS routes. Select this option to display only BGP routes. Select this option to display all the related entries in the routing database instead of just the best route. Select this option to display only hardware routes. Hardware routes are routes that have been written into the hardware chip. Select this option to display a summary and count of the route sources configured on this Switch. Click the Find button to locate a specific entry based on the information entered. Enter a page number and click the Go button to navigate to a specific page when multiple pages exist. Route Preference This window is used to display and configure the route preference settings. Use this window to configure the distance, which represents the route's trust rating. The route with a lower distance value is preferred over the route with a higher distance value. A route with the distance 255 will not be installed for routing of packets since it indicates that the route is not trusted. To view the following window, click L3 Features > Route Preference, as shown below: Figure 6-27 Route Preference Window The fields that can be configured are described below: 232