D-Link DMS-3130-30TS Product Manual - Page 37

DMS-3130 Series Layer 3 Stackable Managed Switch Hardware Installation Guide Creating a User Account One of the first and most important tasks will be to create user accounts. Logging in using a predefined administratorlevel username will give the user privileged access to the Switch's management software. Also this will prevent unauthorized access to the Switch and record the passwords for future reference. An example to create an administrator-level account for the Switch called 'NewUser': Switch#enable Switch#configure terminal Switch(config)#username NewUser password 12345 Switch(config)#username NewUser privilege 15 Switch(config)#line console Switch(config-line)#login local Switch(config-line)#end Switch# In the example above: 1. At the CLI command prompt, enter the enable command to enter the Privileged EXEC Mode. Press Enter. 2. Enter the configure terminal command to enter the Global Configuration Mode. Press Enter. 3. Enter the username NewUser password 12345 command. Press Enter. This will create a user account with the username of NewUser and a password of 12345. 4. Enter the username NewUser privilege 15 command. Press Enter. This will configure this user account to have Administrative (15) privileges. 5. Enter the line console command to enter the Line Configuration Mode. Press Enter. 6. Enter the login local command. Press Enter. This specifies that the local line requires login credentials. 7. Enter the end command to exit back to the Privileged EXEC Mode. NOTE: Passwords are case sensitive. Usernames can be up to 32 characters in length. Passwords can be up to 32 plain-text characters. Configuring the IP Address Each switch must be assigned its own in-band IP Address, which is used for communication with an SNMP network manager or other TCP/IP applications. The Switch's default IP address is 10.90.90.90 with a subnet mask of 255.0.0.0. You can change the IP address of the Switch to meet the specification of your networking address scheme. The IP address of the Switch must be configured before it can be managed, by the user, via the Web UI. An example to change the IP address of the Switch to '10.50.50.50', using a subnet mask of '255.0.0.0': Switch>enable Switch#configure terminal Switch(config)#interface vlan 1 Switch(config-if)#ip address 10.50.50.50 255.0.0.0 Switch(config-if)# In the above example, 1. We accessed the Privileged EXEC Mode by entering the command enable. 2. Then we entered the Global Configuration Mode by entering the command, configure terminal. 3. Then we entered the VLAN Configuration Mode of the default VLAN, which is VLAN 1, by entering the command, interface vlan 1. 4. Then we changed the IP address of the Switch to 10.50.50.50 and the subnet mask to 255.0.0.0 by entering the command ip address 10.50.50.50 255.0.0.0. The Switch can now be accessed and configured through Telnet or the Web UI. The Switch's IP address can also automatically be obtained by using the DHCP protocol. 37