D-Link H.265 User Manual 1.30 WW - Page 53

Enable, SNMPv1/v2c, Read/Write, Community, Read-Only, Trap Address, Trap Port, Advanced Setup >SNMP

Get D-Link H.265 PDF manuals and user guides View all D-Link H.265 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 53 highlights

Section 3: Configuration SNMP Go to Advanced Setup >SNMP to set the Simple Network Management Protocol (SNMP) settings for the camera. Click Save at any time to save the changes. Enable Enable this option to allow for SNMPv1 and SNMPv2c management of the SNMPv1/v2c camera. Read/Write Community Enter a name for the read-write community of your SNMP server. Read-Only Community Enter a name for the read-only community of your SNMP server. Trap Address Enter the IP address where SNMP traps should be sent. Trap Port Enter port of the IP address to which the trap messages will be sent. Trap Community Enter the SNMP trap community name. D-Link Vigilance H.265 Outdoor Bullet Camera User Manual 53

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
53
D-Link Vigilance H.265 Outdoor Bullet Camera User Manual
Section 3: Configuration
SNMP
Enable
SNMPv1/v2c
Read/Write
Community
Read-Only
Community
Trap Address
Trap Port
Trap
Community
Enable this option to allow for SNMPv1 and SNMPv2c management of the
camera.
Enter a name for the read-write community of your SNMP server.
Enter a name for the read-only community of your SNMP server.
Enter the IP address where SNMP traps should be sent.
Enter port of the IP address to which the trap messages will be sent.
Enter the SNMP trap community name.
Go to
Advanced Setup >SNMP
to set the Simple Network Management Protocol (SNMP) settings for the camera. Click
Save
at any time to save
the changes.