Dacor RNHE48 Installation Instructions - Page 18

Installation Instructions Hanging the Range Hood WARNING Hanging the range hood requires two people. Do not lift the hood unassisted. IMPORTANT Take care not to scratch/damage the hood. Rear-Vent Configuration 2. Drill screwholes in the flanges, being sure to pierce the hood top. 3. With sheet-metal screws, fasten the AHT10 unit to the hood. 4. With foil tape/duct tape, seal the AHT10 unit's base. 1. Remove the plastic film from the hood. IMPORTANT Hanging slots in the hood back engage the holding brackets to support the hood temporarily during installation. 2. Lift, and slip the hood onto the holding brackets through the hanging slots in the hood back. Holding brackets 12"-Tall Hood, Rear-Vent Configuration This procedure instructs you how to install the AHT10 transistion kit for 12"-tall rear-vent configuration, comprising Models 3012, 3612, and 4812. 1. Center the transition kit over the duct collars, laying the unbent flange on the hood's top edge. Unbent flange overlaps top of hood 3. Adjust the hood into its final position. 4. Mark the spot by drawing in a mounting hole in the back of the hood. (This is where a screw will hold the hood to the wall stud or concrete anchor.) 2. Drill screwholes in the flanges, being sure to pierce the hood top/back. 3. With sheet-metal screws, fasten the AHT10 unit to the hood. 4. With foil tape/duct tape, seal the AHT10 unit's base. 16