Dacor RNHE48 Installation Instructions - Page 20

Installation Instructions WARNING • Do not ground the circuit to a gas line. • Do not ground the circuit to a hot water pipe. • Insulated water lines must be jumped to assure continuity to the ground. (See below.) To house circuit breaker panel or fuse box Separate No. 10 (minimum) copper ground wire Wire nut, 3 places GREEN GREEN UL/CSA-approved NEMA strain relief WHITE WHITE BLACK BLACK Fasten clamp tightly on metal pipe Meter No. 4 copper wire Junction box To Range Hood Clamps Bare metal Insulated Pipe Jumper (if necessary) Grounding by External Cold-Water Pipe Inserting Light Bulbs Be sure to use dimmable bulbs. The electronic board was designed for dimmable lights. Using non-dimmable bulbs causes damage and faulty performance. Before changing bulbs, shut the main circuit breaker OFF. An electrical short while the main power circuit is ON, can cause significant damage. If needed, clean the lens surface so the suction cup will stick to it. Perform this procedure for each hood light. 1. Attach the suction cup to the lens of a dimmable light bulb (both supplied, see the graphic at right). 2. Screw the bulb into the light fixture, and remove the suction cup. 3. Switch the main circuit power ON. Replacement Part # 702666 Description Dimmable LED Bulb Replacement Kit (1 bulb + 1 suction-cup tool) 18