Dacor RNHE48 Installation Instructions - Page 21
Verifying the Setup, Installation Checklist
View all Dacor RNHE48 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Installation Instructions Verifying the Setup 1. Turn OFF the main power switch. OFF ON 2. Turn power ON at the circuit panel or fusebox. 3. Turn ON the main power switch. The button panel flashes several times during startup. 4. Insert the filters gently: a. Do not scratch the back of the grease channel! b. Set the front edge into the clip, and press forward. Main Power Switch Detail/ Hood Bottom c. (Taking care not to scratch the grease channel or other hood/filter surfaces) Lift the rear edge above the grease channel. d. Set the filter rear edge onto the grease channel. 5. On the hood feature-button panel, press the LIGHTS button to verify that all lights turn on. 6. Press the LIGHTS button again to turn the lights to the Low setting. 7. Press the LIGHTS button again to turn the lights off. 8. Press/release the FAN button to verify that one fan- speed indicator turns on and the fan is on at low speed. 9. Slowly press/release the FAN button three times: a. to verify that the number of lights and fan speed increases each time, then b. press the FAN button again to turn the fan OFF If the Hood Fails to Function Correctly: 1. Verify that power is supplied to the hood. 2. Remove the right-most filter to access the main power switch behind the button panel, and confirm the main power switch is ON. 3. Verify that the electrical connections are correctly done. 4. Perform the Verify the Setup procedure again. IMPORTANT If the hood still does not work, contact Dacor Distinctive Service: (800) 793-0093 x2822. Do not try to repair the appliance yourself. Dacor is not responsible for service required to correct a faulty installation. Installation Checklist FAN LIGHTS TIMER Feature-Button Panel Grease channel Filter WARNING • To ensure a safe and correct installation, this checklist should be completed by the installer to ensure complete and proper installation. • The homeowner is responsible for the Dacor range hood's proper installation, the importance of which cannot be overstated. □□The hood is properly attached to the wall per the instructions on Pgs. 11 and 16. □□Ducting is fully installed; joints are secured with sheetmetal screws and wrapped with foil tape. See Pg. 19. □□The hood is wired/grounded as instructed and per all applicable electric codes. See Pgs. 7, 19. □□Filters are assembled as instructed on Pg. 18. □□The setup was verified. □□Any problems were noted on the warranty card or during the online warranty activation. The warranty card was completed and mailed, or the warranty activated online. 19