Dacor RNHE48 Installation Instructions - Page 9

Preparation and Setup • See the diagram below: Top/Rear Electrical Access Holes for wire hole locations inside the hood. • See Wiring Diagrams at the end of this document. Meeting Installation Requirements WARNING • Observe all governing codes and ordinances during planning and installation. Contact your local building department for details. Use only ductwork accepted by state, municipal, and local codes. • To reduce risk of injury from reaching over a hot appliance, do not place cabinets directly over the range. IMPORTANT See the diagram for minimum installed distance from the hood to the cooktop surface. The minimum specified distance may be higher for the particular range or cooktop in use. Check the manufacturers specifications for the cooktop or range. Top/Rear Electrical Access Holes Installing the Electrical Source In compliance with local codes, install an electrical junction box near the hood's electrical access holes. • The hood must be at least as wide as the cooktop. • All dimensions must meet or fall within the specified minimums. • Dimensions given are minimum clearances unless otherwise noted. • All contact surfaces between the hood and cabinetry/ walls must be sturdy, solid, and at right angles. • Install the hood and cooking appliance(s) so they can be removed for service. Junction Box Area Hood Suggested Area of Junction Box 1. In the cabinet or wall, drill 7/8" holes through which to pass the electrical wiring. 2. See the last pages of this guide for wiring diagrams. 7