Dell Alienware m15 Service Manual - Page 47
Procedure to remove M.2 2280 solid-state drive, M.2 2280 Intel Optane
View all Dell Alienware m15 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
3 Remove the screw (M2x3) that secures the M.2 2230 solid-state drive bracket to the palm-rest assembly. 4 Slide and remove the M.2 2230 solid-state drive along with the bracket from the M.2 slot on the system board. 5 Remove the screw (M1.6x2) that secures M.2 2230 solid-state drive to the solid-state drive bracket. 6 Lift the M.2 2230 card off the solid-state drive bracket. Procedure to remove M.2 2280 solid-state drive NOTE: This procedure applies only to systems shipped with a M.2 2280 solid-state drive installed. NOTE: Depending on the configuration ordered the system may have up to two M.2 solid-state drives installed. Supported solid-state drive configurations per M.2 solid-state drive slot: • M.2 2230 solid-state drive + solid-state drive bracket • M.2 2280 solid-state drive • M.2 2280 Intel Optane NOTE: For solid-state drives above 512 GB or Intel Optane above 118 GB a thermal shield is required for optimal heat dissipation and is installed in the computer when these configurations are ordered. If these configurations are installed After Point-of-Sale (APOS), contact Dell support for the thermal shield. NOTE: Depending on the number of M.2 solid-state drives installed at Point-of-Sale, the thermal shield installed in the computer may be a full shield or a half shield. If two M.2 solid-state drives are installed After Point-of-Sale (APOS) contact Dell support for the full thermal shield. 1 Remove the two screws (M2x3) that secure the M.2 thermal shield to the palm-rest assembly and system board. 47