Dell Force10 S2410-01-10GE-24P SFTOS Command Reference - Page 217

12 Stacking Commands This chapter provides a detailed explanation of the stacking commands. The commands are listed under two headings: • Stacking on page 217 • Slot and Card Commands on page 226 See also the copy and Dual Image Management Commands on page 119 in the System Configuration chapter. Stacking This section provides detailed explanations of the commands that manage the stacking of S-Series switches into a single virtual switch: • archive copy-sw on page 217 • archive download-sw on page 218 • on page 218 • movemanagement on page 219 • reload on page 219 • show stack-port on page 219 • show stack-port diag on page 220 • show switch on page 221 • show supported switchtype on page 223 • stack on page 224 • switch priority on page 225 • switch renumber on page 225 archive copy-sw This command replicates the SFTOS software image (.OPR file) from the management unit to the other switch(es) in the stack. The code is loaded on the destination system unit, if specified, otherwise the code is loaded on all switches in the stack. Switch(es) must be reset for the new code to start running. Syntax sOiabEuOedI6dneAsutination-system unit Mode Stacking Config (prompt is "(config-stack)#") Note: This command must be executed only if the new unit is added to a stack that is running a different version than the management unit. Stacking Commands | 217