Dell Force10 S25-01-GE-24V FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 1002

www.dell.com | support.dell.com track ipv6 route metric threshold c e s Configure object tracking on the threshold of an IPv4 route metric. Syntax track object-id ipv6 route ipv6-address/prefix-len metric threshold To return to the default setting, enter no track object-id. Parameters object-id ipv6-address/ prefix-len Enter the ID number of the tracked object. Range: 1 to 65535. Enter an IPv6 address in X:X:X:X::X format. Valid IPv6 prefix lengths are from /0 to / 128. Defaults None Command Modes CONFIGURATION Command History Related Commands Version 8.4.1.0 Introduced show track ipv6 route threshold metric track resolution ipv6 route Display information about tracked IPv6 routes, including configuration, current state, and clients which track the route. Configure the metric threshold used to determine the UP and/or DOWN state of a tracked route. Configure the protocol-specific resolution value used to scale an IPv6 route metric. Usage Use this command to create an object that tracks the UP and/or DOWN threshold of an IPv6 route Information metric. In order for a route's metric to be tracked, the route must appear as an entry in the routing table. A tracked IPv6 route is considered to match an entry in the routing table only if the exact IPv6 address and prefix length match a table entry. For example, when configured as a tracked route, 3333:100:200:300:400::/80 does not match routing table entry 3333:100:200:300::/64. If no route-table entry has the exact IPv6 address and prefix length, the status of the tracked route is considered to be DOWN. When you configure the threshold of an IPv6 route metric as a tracked object, the UP/DOWN state of the tracked route is also determined by the current metric for the route in the routing table. To provide a common tracking interface for different clients, route metrics are scaled in the range 0 to 255, where 0 is connected and 255 is inaccessible. The scaled metric value communicated to a client always considers a lower value to have priority over a higher value. The resulting scaled value is compared against the configured threshold values to determine the state of a tracked route as follows: • If the scaled metric for a route entry is less than or equal to the UP threshold, the state of a route is UP. • If the scaled metric for a route is greater than or equal to the DOWN threshold or the route is not entered in the routing table, the state of a route is DOWN. You configure the UP and DOWN thresholds for each tracked IPv6 route by using the threshold metric command. The default UP threshold is 254; the default DOWN threshold is 255. The notification of a change in the state of a tracked object is sent when a metric value crosses a configured threshold. 1002 | Object Tracking