Dell Force10 S25-01-GE-24V FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 1487
vrrp-group, E-Series ExaScale only, E-Series ExaScale and TeraScale only, vrrp-ipv6-group, ip vrf
View all Dell Force10 S25-01-GE-24V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1487 highlights
vrrp-group c e s Assign an interface to a VRRP group. Syntax vrrp-group vrid Parameters vrid Enter the virtual-router ID number of the VRRP group. VRID range (C-Series and S-Series): 1-255. VRID range (E-Series): 1-255 when VRF microcode is not loaded and 1-15 when VRF microcode is loaded. Defaults Not configured. Command Modes INTERFACE Command History Version 8.4.2.1 Version 8.4.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 When VRF microcode is loaded in CAM, the range of valid VRID values on the E-Series changed to 1-15. Support was added for configuring a VRRP group on an interface in a non-default VRF instance. Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage The VRRP group only becomes active and sends VRRP packets when a virtual IP address is Information configured. When you delete the virtual address, the VRRP group stops sending VRRP packets. Starting in release 8.4.1.0, you can configure a VRRP group on an interface in a non-default VRF instance. E-Series ExaScale only: You can configure up to 16 VRRP groups per VLAN and up to 511 groups on all VLANs. E-Series ExaScale and TeraScale only: Starting in release 8.4.2.1, you can configure up to 255 VRRP groups per interface if VRF microcode is not loaded, and up to 15 groups if VRF microcode is loaded. E-Series ExaScale and TeraScale only: Starting in release 8.4.2.1, the VRID used by the VRRP protocol changes according to whether VRF microcode is loaded or not: • When VRF microcode is not loaded in CAM, the VRID for a VRRP group is the same as the VRID number configured with the vrrp-group or vrrp-ipv6-group command. • When VRF microcode is loaded in CAM, the VRID for a VRRP group is equal to 16 times the vrrp-group or vrrp-ipv6-group vrid number plus the ip vrf vrf-id number. For example, if VRF microcode is loaded and VRRP group 10 is configured in VRF 2, the VRID used for the VRRP group is (16 x 10) + 2, or 162. This VRID value is used in the lowest byte of the virtual MAC address of the VRRP group and is also used for VRF routing. Virtual Router Redundancy Protocol (VRRP) | 1487