Dell Force10 S25-01-GE-24V FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 771
neighbor, route-map, no neighbor, route-reflector-client
View all Dell Force10 S25-01-GE-24V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 771 highlights
Syntax neighbor {ipv6-address | peer-group-name} route-map map-name {in | out} To remove the route map, use the no neighbor {ipv6-address | peer-group-name} route-map map-name {in | out} command. Parameters ipv6-address peer-group-name map-name in out Enter the IPv6 address in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zeros. Enter the name of the peer group. Enter the name of an established route map. If the Route map is not configured, the default is deny (to drop all routes). Enter the keyword in to filter inbound routes. Enter the keyword out to filter outbound routes. Defaults Not configured. Command Modes ROUTER BGPV6-ADDRESS FAMILY Command History Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on C-Series and S4810. Introduced on E-Series ExaScale Introduced on E-Series TeraScale Usage When you apply a route map to outbound routes, only routes that match at least one section of the route Information map are permitted. If you identify a peer group by name, the peers in that peer group inherit the characteristics in the Route map used in this command. If you identify a peer by IP address, the Route map overwrites either the inbound or outbound policies on that peer. neighbor route-reflector-client c e Configure a neighbor as a member of a route reflector cluster. Syntax neighbor {ipv6-address | peer-group-name} route-reflector-client To indicate that the neighbor is not a route reflector client or to delete a route reflector configuration, use the no neighbor {ipv6-address | peer-group-name} route-reflector-client command. Parameters ipv6-address peer-group-name Enter the IPv6 address in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zeros. Enter the name of the peer group. All routers in the peer group receive routes from a route reflector. Defaults Not configured. Command Modes ROUTER BGPV6-ADDRESS FAMILY IPv6 Border Gateway Protocol (IPv6 BGP) | 771