Dell Force10 S25-01-GE-24V FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 838

www.dell.com | support.dell.com isis hello-multiplier e Specify the number of IS-IS hello packets a neighbor must miss before the router declares the adjacency down. Syntax isis hello-multiplier multiplier [level-1 | level-2] To return to the default values, enter no isis hello-multiplier [multiplier] [level-1 | level-2]. Parameters multiplier level-1 level-2 Specifies an integer that sets the multiplier for hello holding time. Never configure a hello-multiplier lower then the default (3). Range: 3 to 1000 Default: 3 (OPTIONAL) Select this value to configure the hello multiplier independently for Level 1 adjacencies. This is the default. (OPTONAL) Select this value to configure the hello multiplier independently for Level 2 adjacencies. Defaults multiplier =3; level-1 (if not otherwise specified) Command Modes INTERFACE Usage Information The holdtime (the product of the hello-multiplier multiplied by the hello-interval) determines how long a neighbor waits for a hello packet before declaring the neighbor is down so routes can be recalculated.I Related Commands isis hello-interval Specify the length of time between hello packets. isis hello padding e Turn ON or OFF padding of hello PDUs from the interface mode. Syntax isis hello padding To return to the default, use the no isis hello padding. Defaults Padding of hello PDUs is enabled (ON). Command Modes INTERFACE Usage Hello PDUs are "padded" only when both the global and interface padding options are ON. Turning Information either one OFF will disable padding for the corresponding interface(s). Related Commands hello padding Turn ON or OFF padding for LAN and point-to-point hello PDUs. 838 | Intermediate System to Intermediate System (IS-IS)