Dell Force10 S25-01-GE-24V FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 1325

deny udp e Configure a filter to drop UDP packets meeting the filter criteria. Syntax deny udp {source mask | any | host ip-address} [operator port [port]] {destination mask | any | host ip-address} [operator port [port]] [count [byte]] | log] [order number] To remove this filter, you have two choices: • Use the no seq sequence-number command syntax if you know the filter's sequence number or • Use the no deny udp {source mask | any | host ip-address} {destination mask | any | host ip-address} command. Parameters source mask any host ip-address operator port port destination mask count byte log order number Enter the IP address of the network or host from which the packets were sent. (OPTIONAL) Enter a network mask in /prefix format (/x). Enter the keyword any to specify that all routes are subject to the filter. Enter the keyword host followed by the IP address to specify a host IP address. (OPTIONAL) Enter one of the following logical operand: • eq = equal to • neq = not equal to • gt = greater than • lt = less than • range = inclusive range of ports (OPTIONAL) Enter the application layer port number. Enter two port numbers if using the range logical operand. Range: 0 to 65535 Enter the IP address of the network or host to which the packets are sent. (OPTIONAL) Enter a network mask in /prefix format (/x). (OPTIONAL) Enter the keyword count to count packets processed by the filter. (OPTIONAL) Enter the keyword byte to count only bytes (OPTIONAL) Enter the keyword log to have the information kept in a Trace-list log file. (OPTIONAL) Enter the keyword order followed by a number from 0 to 7 as the order number. Defaults Not configured. Command Modes TRACE LIST Related Commands deny deny tcp Assign a trace list filter to deny IP traffic. Assign a trace list filter to deny TCP traffic. Security | 1325