Dell Force10 S25-01-GE-24V FTOS 8.4.2.7 Command Line Reference Guide for E-Ser - Page 1474

www.dell.com | support.dell.com start-vlan-id e Set the starting VLAN ID for a VRF instance. Note: Starting in FTOS 8.4.2.1, when VRF microcode is loaded on an E-Series ExaScale or TeraScale router, the start vlan-id vlan-start-id command is deprecated. Syntax start-vlan-id vlan-start-id Parameters vlan-start-id The starting VLAN ID number for this VRF instance. The system takes this number and adds up the number of VLANs assigned in ip-vrf-vlan-block to set the start and end range for the VRF VLANs. Command Modes CONFIGURATION-VRF Command History Version 8.4.2.1 Version 8.2.1.0 The start vrf-vlan-id vlan-start-id command is deprecated. Introduced on the E-Series Example FTOS(conf)#ip vrf default-vrf FTOS(conf-vr-default-vrf)#start-vlan-id 32 FTOS(conf-vr-default-vrf)# ! FTOS(conf-vr-default-vrf)#ip vrf East FTOS(conf-vr-East)#start-vlan-id 1 FTOS(conf-vr-East)#ip vrf West ! FTOS(conf-vr-West)#start-vlan-id 96 FTOS(conf-vr-West)# Usage Information If a given VLAN is not in the range of any VRF, no VRF command can be configured for that VLAN. All VLAN member ports must be removed from the VLAN before the VLAN is deleted from a VRF instance. This also applies when moving a VLAN from one VRF to another: delete all member ports, then delete the VLAN prior to adding it to another VRF. Related Commands ip vrf forwarding ip vrf-vlan-block show run vrf Assign this interface to the VLAN specified. Configure the total number of VLANs that can be configured per VRF. View information about the current running VRF instances. 1474 | Virtual Routing and Forwarding (VRF)