Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 556

www.dell.com | support.dell.com • ipv6 access-group • ipv6 access-list • permit • permit icmp • permit tcp • permit udp • remark • resequence access-list • resequence prefix-list ipv6 • seq • show cam-acl • show config • show ipv6 accounting access-list • show running-config acl • test cam-usage cam-acl c s Allocate space for IPv6 ACLs. Syntax cam-acl {default | l2acl 1-10 ipv4acl 1-10 ipv6acl 0-10 ipv4qos 1-10 l2qos 1-10} Parameters default l2acl 1-10 ipv4acl 1-10 ipv6acl 0-10 ipv4qos 1-10 l2qos 1-10 Use the default CAM profile settings, and set the CAM as follows. L3 ACL (ipv4acl): 6 L2 ACL(l2acl) : 5 IPv6 L3 ACL (ipv6acl): 0 L3 QoS (ipv4qos): 1 L2 QoS (l2qos): 1 Allocate space to support IPv6 ACLs. You must enter all of the profiles and a range. Enter the CAM profile name followed by the amount to be allotted. The total space allocated must equal 13. The ipv6acl range must be a factor of 2. Command Modes CONFIGURATION Command History Version 8.3.3.1 Version 8.2.1.0 Version 7.8.1.0 Introduced on the S60. Introduced on the S-Series Introduced on the C-Series Usage You must save the new CAM settings to the startup-config (write-mem or copy run start) then Information reload the system for the new settings to take effect. The total amount of space allowed is 16 FP Blocks. System flow requires 3 blocks and these cannot be reallocated. When configuring space for IPv6 ACLs, the total number of Blocks must equal 13. 556 | IPv6 Access Control Lists (IPv6 ACLs)