Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 787

switchport mode private-vlan c s Set the PVLAN mode of the selected port. Syntax [no] switchport mode private-vlan {host | promiscuous | trunk} Parameters To remove the PVLAN mode from the selected port, use the no switchport mode private-vlan command. host promiscuous trunk Enter host to configure the selected port or port channel as an isolated interface in a PVLAN, as described above. Enter promiscuous to configure the selected port or port channel as an promiscuous interface, as described above. Enter trunk to configure the selected port or port channel as a trunk port in a PVLAN, as described above. Defaults Command Modes Command History disabled INTERFACE Version 8.3.3.1 Version 7.8.1.0 Introduced on S60 Introduced on C-Series and S-Series Usage Information Example The assignment of the various PVLAN port types to port and port channel (LAG) interfaces is demonstrated below. Figure 30-6. Examples of switchport mode private-vlan Command Force10#conf Force10(conf)#interface GigabitEthernet 2/1 Force10(conf-if-gi-2/1)#switchport mode private-vlan promiscuous Force10(conf)#interface GigabitEthernet 2/2 Force10(conf-if-gi-2/2)#switchport mode private-vlan host Force10(conf)#interface GigabitEthernet 2/3 Force10(conf-if-gi-2/3)#switchport mode private-vlan trunk Force10(conf)#interface port-channel 10 Force10(conf-if-gi-2/3)#switchport mode private-vlan promiscuous Related Commands private-vlan mode private-vlan mapping secondary-vlan show interfaces private-vlan show vlan private-vlan mapping Set the mode of the selected VLAN to either community or isolated. Set the mode of the selected VLAN to primary and then associate secondary VLANs to it. Display type and status of PVLAN interfaces. Display primary-secondary VLAN mapping. Private VLAN (PVLAN) | 787