Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 777

show running-config monitor session c e s Display the running configuration of all monitor sessions or a specific session. Syntax show running-config monitor session {session-ID} To display the running configuration for all monitor sessions, use just the show running-config monitor session command. Parameters session-ID (OPTIONAL) Enter a session identification number. Range: 0 to 65535 Defaults No default values or behavior Command Modes EXEC EXEC Privilege Command History Version 8.3.3.1 Version 8.1.1.0 Version 7.7.1.0 Version 7.5.1.0 Version 7.4.1.0 Introduced on S60 Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced on E-Series Example Force10#show running-config monitor session ! monitor session 8 source GigabitEthernet 10/46 destination GigabitEthernet 10/1 direction rx ! monitor session 11 source GigabitEthernet 10/0 destination GigabitEthernet 10/47 direction rx Force10#show running-config monitor session 11 ! monitor session 11 source GigabitEthernet 10/0 destination GigabitEthernet 10/47 direction rx Usage Information Related Commands The monitoring command is saved in the running configuration at the Monitor Session mode level and can be restored after a chassis reload. monitor session show monitor session Create a session for monitoring. Display a monitor session. source c e s Configure a port monitor source. Syntax source interface destination interface direction {rx | tx | both} To disable a monitor source, use the no source interface destination interface direction {rx | tx | both} command. Port Monitoring | 777