Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 72

www.dell.com | support.dell.com Usage Information Version 8.1.1.0 Version 6.2.1.1 Version 6.1.1.0 Introduced on E-Series ExaScale E1200i Support for E300 introduced (10.4 only) Values changed as described above You save the configuration and reload the chassis for the changes to the epoch command setting to take affect. When using 10 SFMs in an ExaScale chassis, the 10.4 and 2.4 settings are both linerate. Additionally, the 2.4 setting has a lower latency. When using 9 SFMs in an ExaScale chassis, the 10.4 setting is linerate; the 2.4 setting reduces throughput. Dell Force10 recommends using the 10.4 setting when the system has 9 SFMs. Using 8 SFMs in an ExaScale chassis reduces throughput at any epoch setting. Note: The E300 supports only the 10.4 epoch setting. The E-Series TeraScale E600/E600i and the E1200/E1200i systems support the 10.4 and the 3.2 epoch settings. Note: For E-Series ExaScale, the 2.4 setting is supported on FTOS version 8.3.1.0 and later. The 10.4 setting is supported on all ExaScale FTOS versions. The 3.2 setting is only supported on FTOS versions 8.2.1.0 and earlier. exec-banner c e s Enable the display of a text string when the user enters the EXEC mode. Syntax exec-banner To disable the banner on terminal lines, enter no exec-banner. Defaults Command Modes Command History Enabled on all lines (if configured, the banner appears). LINE Version 8.3.3.1 Introduced on the S60. Version 8.1.1.0 Introduced on E-Series ExaScale Version 7.6.1.0 Introduced on S-Series Version 7.5.1.0 Introduced on C-Series E-Series original Command Usage Related Commands Optionally, use the banner exec command to create a text string that is displayed when the user accesses the EXEC mode. This command toggles that display. banner exec line Configure a banner to display when entering the EXEC mode. Enable and configure console and virtual terminal lines to the system. 72 | Control and Monitoring