Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 979

snmp-server packetsize c e s Set the largest SNMP packet size permitted when the SNMP server is receiving a request or generating a reply, use the snmp-server packetsize global configuration command. Syntax snmp-server packetsize byte-count Parameters byte-count Enter one of the following values 8, 16, 24 or 32. Packet sizes are 8000 bytes, 16000 bytes, 32000 bytes, and 64000 bytes. Defaults 8 Command Modes CONFIGURATION Command History Version 8.3.3.1 Introduced on S60 Version 7.6.1.0 Support added for S-Series Version 7.5.1.0 Support added for C-Series E-Series legacy command snmp-server trap-source c e s Configure a specific interface as the source for SNMP traffic. Syntax snmp-server trap-source interface To disable sending traps out a specific interface, enter no snmp trap-source. Parameter interface Enter the following keywords and slot/port or number information: • For an 100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Loopback interface, enter the keyword loopback followed by a number from 0 to 16383. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. Defaults The IP address assigned to the management interface is the default. Command Modes CONFIGURATION Command History Version 8.3.3.1 Introduced on S60 Version 7.6.1.0 Support added for S-Series Version 7.5.1.0 Support added for C-Series E-Series legacy command Usage For this snmp-server trap-source command to be enabled, you must configure an IP address on the Information interface and enable the interface configured as an SNMP trap source. SNMP and Syslog | 979