Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 57

Related Commands Once the URL is specified, the same downloaded image can be used for upgrading an individual RPM, line cards, SFM FPGA, and system-image for cache-boot without specifying the file-url again using the command upgrade {bootflash-image | bootselector-image | system-image} {all | linecard linecard-slot | rpm}. After 20 minutes, the cached memory is released and returned for general use, but the URL is maintained and you do not have to specify it for subsequent upgrades. upgrade fpga-image (E-Series) boot system (S60) Upgrade the FPGA version in the specified E-Series SFM. Display configured boot image information upgrade (S-Series management unit) s Upgrade the bootflash image or system image of the S-Series management unit. Syntax Parameters upgrade {boot | system} {ftp: | scp: | tftp: | flash: {A: |B:} | stack-unit | usbflash:} file-url boot system ftp: scp: tftp: flash: A: | B: stack-unit: usbflash: Enter this keyword to change the boot image. Enter this keyword to change the system image. After entering this keyword you can either follow it with the location of the source file in this form: //userid:password@hostip/filepath, or press Enter to launch a prompt sequence. After entering this keyword you can either follow it with the location of the source file in this form: //userid:password@hostip/filepath, or press Enter to launch a prompt sequence. After entering this keyword you can either follow it with the location of the source file in this form: //hostlocation/filepath, or press Enter to launch a prompt sequence. After entering this keyword you can either follow it with the location of the source file in this form: flash//filepath,or press Enter to launch a prompt sequence. S60 only Enter the partition to upgrade from the flash. S60 only After entering this keyword to synch the image to the stack-unit. After entering this keyword you can either follow it with the location of the source file in this form: usbflash://filepath, or press Enter to launch a prompt sequence. S60 only Defaults Command Modes Command History No configuration or default values EXEC Privilege Version 8.3.3.1 Version 7.7.1.0 Version 7.6.1.0 Introduced on the S60 Added support for TFTP and SCP. Introduced on S-Series File Management | 57