Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 88

www.dell.com | support.dell.com rpm number sfm slot number Enter the keyword rpm followed by a number for the RPM slot number. (Optional) Add the keyword hard or power-cycle (C-Series only) to power cycle the RPM. Range: 0 to 1 Enter the keyword sfm followed by the failed or powered-off SFM slot number. Note: Supported on E-Series only Defaults Disabled. Command Modes EXEC Privilege Command History Version 7.5.1.0 Introduced on C-Series E-Series original Command Usage Information The command reset without any options is a soft reset, which means FTOS boots the line card from its runtime image. The hard option reloads the FTOS image on the line card. Use the power-cycle after upgrading an FPGA. When a soft reset is issued on a line card (reset linecard number), FTOS boots the line card from its runtime image. Only when you enter reset linecard number hard is the software image reloaded on the line card. Related Commands reload restore fpga-image Reboots the system. Copy the backup C-Series FPGA image to the primary FPGA image. rpm location-led ex Toggle the location LED on/off on the E-Series ExaScale RPM (LC-EH-RPM). Syntax rpm slot number location-led [on | off] Parameters rpm slot number on |off Enter the slot number E1200i: 0-13 E600i: 0-6 Toggles the LED on the RPM on or off. Defaults OFF Command Modes EXEC Command History Version 8.2.1.0 Introduced on the E-Series ExaScale Usage The LED setting is not saved through power cycles. Information 88 | Control and Monitoring