Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 962

www.dell.com | support.dell.com Parameters enable Enter the keyword enable to enable global extended information. Defaults Disabled Command Modes CONFIGURATION Command History Version 8.3.3.1 Version 8.2.1.0 Version 8.1.1.0 Version 7.7.1.0 Version 7.6.1.0 Version 7.4.1.0 Introduced on S60 Introduces on S-Series Stacking Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage Information FTOS 7.8.1.0 and later enhances the sFlow implementation for real time traffic analysis on the E-Series to provide extended gateway information in cases where the destination IP addresses are learned by different routing protocols, and for cases where the destination is reachable over ECMP. Related Commands sflow extended-gateway enable sflow extended-router enable show sflow Enable packing information on an extended gateway. Enable packing information on a router. Display the sFlow configuration sflow polling-interval (Global) c e s Set the sFlow polling interval at a global level. Syntax sflow polling-interval interval value To return to the default, use the no sflow polling-interval interval command. Parameters interval value Enter the interval value in seconds. Range: 15 to 86400 seconds Default: 20 seconds Defaults 20 seconds Command Modes CONFIGURATION Command History Version 8.3.3.1 Version 8.2.1.0 Version 8.1.1.0 Version 7.7.1.0 Version 7.6.1.0 Version 6.2.1.1 Introduced on S60 Introduces on S-Series Stacking Introduced on E-Series ExaScale Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage Information The polling interval for an interface is the maximum number of seconds between successive samples of counters to be sent to the collector. This command changes the global default counter polling (20 seconds) interval. You can configure an interface to use a different polling interval. 962 | sFlow