Dell Force10 S6000 Installation Guide - Page 14

www.dell.com | support.dell.com Table 2-2. 40G QSFP+/ 4x10G SFP+ Ethernet Port LEDs Feature Detailed Description Link/Activity LED • Off - No Link. • Blinking green - Transmit/Receive is active. • Solid green - Link up at 40Gbps/10Gbps speed. Table 2-3. Management Ethernet Port LEDs Feature Detailed Description Link LED • Off - No Link. • Solid green - Link on 10/100M/1G speed. Activity LED • Off - No Link. • Blinking green - Transmit/Receive is active. Basic Installation Requirements Detailed installation instructions for the S6000 are provided in Chapter 3, Site Location and Preparation and Chapter 4, Install the S6000. However, here is an initial list of components required for a successful installation of the S6000: • S6000 switch • If you ordered AC units, cables to connect the AC power source to each of the switch's AC power supplies (country/regional configured) • If you ordered DC units, cables to connect the DC power source to each of the switch's DC power supplies • Mounting brackets for rack installation (included) • Screws for rack installation and #1 and #2 Phillips screwdrivers (not included) • Ground cable (not included) • Ground cable screws (included) • Copper/fiber cables Optional components for installation: • Additional power supply units • Additional fan modules • Additional mounting brackets (if installing in a 4-post rack or cabinet) Orderable S6000 Components You can order the S6000 switch in several different configurations. Also, you can order optional modules and optics separately. The following is a list of different configurations and modules: 14 | The S6000 Switch