Dell Force10 S6000 Installation Guide - Page 27
Installing the S6000 Switch, Installing a 1U Front-Rack
View all Dell Force10 S6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Installing the S6000 Switch You can mount the switch in the 1U front-rack or 1U two-post (flush and center) configurations. The following is an example of a front-rack configuration. For the 1U two-post (flush and center) configurations, slide the switch into the rails in the same manner as the four-post configurations. Installing a 1U Front-Rack You must configure the rails that are attached to the switch. Step Task 1 Attach the switch rails (inner switch members) to the S6000 switch. Figure 4-5, item 3 shows the detail for the front standoff with the locking tab. Figure 4-5. Attaching the Switch Rails Install the S6000 | 27
Install the S6000
|
27
Installing the S6000 Switch
You can mount the switch in the 1U front-rack or 1U two-post (flush and center) configurations. The
following is an example of a front-rack configuration. For the 1U two-post (flush and center)
configurations, slide the switch into the rails in the same manner as the four-post configurations.
Installing a 1U Front-Rack
You must configure the rails that are attached to the switch.
Step
Task
1
Attach the switch rails (inner switch members) to the S6000 switch.
Figure 4-5
, item 3 shows the detail for the
front standoff with the locking tab.
Figure 4-5.
Attaching the Switch Rails