Dell Inspiron 14 1440 Inspiron 14 1440 Service Manual - Page 18

Back to Contents Page Display Dell™ Inspiron™ 1440 Service Manual Display Assembly Display Bezel Display Panel Display Panel Cable WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance. CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface. CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not covered by your warranty. CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the computer. Display Assembly Removing the Display Assembly 1. Follow the procedures in Before You Begin. 2. Remove the battery (see Removing the Battery). 3. Remove the module cover (see Removing the Module Cover). 4. Remove the memory module(s) (see Removing the Memory Module(s)). 5. Remove the hard drive (see Removing the Hard Drive). 6. Remove the optical drive (see Removing the Optical Drive). 7. Remove the two screws from the computer base. 8. Remove the center control cover (see Removing the Center Control Cover). 9. Remove the keyboard (see Removing the Keyboard). 10. Remove the power button board (see Removing the Power Button Board). 11. Remove the palm rest (see Removing the Palm Rest). 12. Disconnect the camera cable from the system board connector. 13. Make note of the Mini-Card antenna cables, camera cable, and the display cable routing and remove the cables from their routing guides.